Fig 1.
Map of the Baltic Sea archipelago (SW Finland) showing the locations of the habitats.
Mixed macrophyte (MM) and bare sand (BS) habitats, exposed seagrass meadow (SG), littoral bladder-wrack belt (FV), and blue mussel reef (BM). A selection of photographs showing the biodiversity sampling area at the MM and BS, the AEC deployed at the SG, and a closer look to the Fucus vesiculosus and blue mussels at the BM and FV rocky beds, respectively.
Table 1.
Aquatic eddy covariance (AEC) deployment information and environmental characteristics (mean±SE).
This table includes information on the AEC footprint area and productivity flux estimates (Gross primary production, GPP, community respiration, R, and net ecosystem metabolism, NEM) at the five habitats. Photosynthetic active radiation (PAR) is calculated as an integration of continuous measurements over 24 h. Xmax is the integrated area with the maximum flux contribution (see [16]).
Fig 2.
Example of eddy covariance data treatment for calculating daily seafloor productivity rates from the MM site.
The collected datasets for PAR (15 min, A) and the eddy fluxes (15 min, B) were bin-averaged by the hour of day to produce a single 24 h time series for PAR (C, mean ± SD, n = 3) and eddy flux (D, mean ± SE, n = 3). The eddy flux time series was separated into day-time and night-time fluxes to compute daily rates of seafloor gross primary productivity (GPP), respiration (R), and net ecosystem metabolism (NEM) (E, in mmol O2 m-2 d-1, see Methods).
Fig 3.
Schematic illustration of the AEC footprint and biodiversity sampling area.
(A) Diagram from above showing the AEC footprint areas determined by different flow directions. The length, width and total area of the AEC footprints for all the habitats are shown in Table 1. The circular biodiversity footprint (80 m2, r = 5 m) was superimposed to the AEC footprint ensuring that the maximum flux contribution measured in all the habitats (Xmax = 5 m) was covered. The grey scale shows a theoretical gradient of the benthic contribution to the flux registered within the footprint area (darker grey implies higher contribution closer to the device). (B) Illustration of the biodiversity footprint area displaying 8 equal wedge-sections for community characterization. Quantitative random samples (n = 8, one replicate sample per each of the 8 wedge-sections) of the main benthic organisms (v macrofauna, macrophytes and macroalgae) were collected (see Methods).
Fig 4.
Estimated characteristics of the AEC footprint.
Mean roughness length (z0) and estimated footprint length versus region of maximum flux contribution (Xmax) for various coastal benthic habitats (Bare sediments: [27,29,31,32, this study]; Coralline algal bed: [27]; Rocky outcrop: [31]; Mussel bed: [this study]; Oyster bed: [20]; Coral reef: [33]; Vegetated canopy: [30,34, this study]). The estimated footprint values (length vs Xmax) for the study sites were allocated (i.e., BS: bare sand; MM: mixed macrophyte; SG: seagrass meadow; FV: bladder-wrack belt; BM: blue mussel).
Fig 5.
Mean (+SE) ecosystem metabolism and benthic biodiversity biomass.
(A) Ecosystem metabolism (GPP: gross primary production, R: community respiration, NEM: net ecosystem metabolism), (B) benthic biomass (dry weight) of macrophytes (Z. marina and Fucus vesiculosus) and macrofauna (total average), and (C) benthic biomass (dry weight) of chlorophyll a (Chl a) and phaeopigments (Phaeo) from all the habitats (FV: bladder-wrack bed, BS: bare sand, MM: mixed macrophyte, SG: seagrass meadow, BM: blue mussel reef). Different letters represent significant differences (p < 0.05) for the main metrics.
Fig 6.
Windrose plots (mean ± SD) for the soft-sediment sites.
(A) Coverage (ArcMap, see section 2.7.) of benthic microalgae (i.e., chlorophyll a), macrophytes, and seagrass, (B) directional flow velocity distribution, and (C) daily seafloor productivity rates for different days or different directions (daily integrated PAR values are indicated).
Fig 7.
Windrose plots (mean ± SD) for rocky substrates.
(A) Coverage (ArcMap, see section 2.7.) of macroalgae and mussels, (B) directional flow velocity distribution, and (C) corresponding seafloor productivity rates, indicating the number of 15 min fluxes.
Table 2.
Mean (±SE) abundance, biomass and the number of species observed at the five habitats.
All the macrofauna was divided between those species associated to the macrovegetation or macroalgae (i.e., epifauna), and those species directly related to the seafloor substrate (i.e., seabed fauna), either buried in the sediment or attached to the rocky bed. Abundance (individuals m-2), biomass (dry weight, g m-2).