Figure 1.
Acquisition and pre-processing of whisker trajectories in rats.
A. Overhead view of a head-fixed rat with whiskers C2, C1, and D1. The instantaneous whisker angle, θ, was defined as the angle between the whisker base and the nose-eye line. The pole is marked schematically in its typical initial location, with an arrow indicating the direction of its motion into the whisking field of the rat. B. The protraction and retraction phases of a single whisk are depicted in relation to whisker angle and protraction onset time. The angle of the whisker on the whisk's onset (set point) is indicated by an arrow. C. Example of a free-air whisking trajectory (filtered at 80 Hz). D. Example of a whisking trajectory against an object (filtered at 80 Hz). Whisker-pole contact is indicated by bold. In this example, the rat made 21 successive whisks with touch.
Figure 2.
Whisking and head motion in freely moving rats.
Examples of whisker trajectories (filtered at 80 Hz) from freely-moving rats performing a localization task [6], demonstrating the occurrence of whisks with a single peak (gray) and multiple peaks (red) after contact onset.
Figure 3.
Fast, within-cycle touch-induced ipsilateral feedback.
A. Angle trajectory from a contact trial, filtered at 80 Hz. Whisker C2 (red) touched the pole near the end of protraction. Touch events are indicated by black horizontal lines. TIPs (manually detected in this example) are indicated by asterisks. The first touch depicted was also the first touch in the trial. Data for ipsilateral C2 (red), ipsilateral C1 (black), and contralateral C2 (blue) whiskers. B. Angle trajectory of whisks with TIP (red) and without (grey), all taken from a single trial. Time and angle are presented with respect to their values at touch onset. C. Example of a touch-induced pump (TIP) that, after contact between whisker C2 and the pole, occurred simultaneously in the three untrimmed whiskers (C1, C2, D1). The C2 whisker was continuously in contact with the pole throughout the period marked touch (bold red line), so the whisker palpates against the pole without detaching from it. The TIP peak or onset (indicated by the arrow), the time of the first peak after touch, is followed by negative velocity. D. Time from touch onset (start of red bold line in C) to TIP onset (arrow in C) in contact trials (purple). The average latency of touch-induced pumps was 17.9 ms. The distribution of times between pseudo-touches (crossing of a threshold angle in free-air trials) and pump onset was normalized to have the same number of touches as in the contact data and is denoted in green. E. Inter-pump-interval (time between touch onsets in two neighboring whisks-with-TIP) with experimental (purple) and simulated (control; green) data. The control distribution is what is expected if the pumps had the same probability to occur, but were distributed randomly upon touch events. The peak around 140 ms is due to pumps that occurred in successive whisks (see Materials and Methods for detailed description on the controls used in Figs. 3D and 3E).
Figure 4.
Contact durations are longer in whisks with TIP.
A. A typical single whisk with a pump after touch onset. Period of whisker-pole contact marked in black. The pump occurred while the whisker stayed in contact with the pole. B. A typical single whisk without a pump after touch onset. C. Touch duration as a function of the position of the touch in a sequence of touches. Whisks with touch and TIP (purple) and whisks with touch but no TIP (gray). D. Touch duration with and without a TIP, as a function of the set point.
Figure 5.
TIPs occur more often in whisk cycles with higher set-points.
A. The average angle trace of whisker C1 (not touching) triggered on the onset of touch by whisker C2 for all whisks with (purple; mean ± SE) and without pumps (grey; mean ± SE). B. Similar to A, but when only data from the first touches in a trial (N = 140) were used. C. Mean trace around touch with TIP (purple) and over a subset of traces around touch with no TIP (control; green) for the data in A. The control subset was chosen by removing traces with the lowest set points, so that the mean set points of the control (green) and pump (purple) traces will be equal. D. Similar to C, but when only data from the first touch occurring in a trial was used.
Figure 6.
Whisking kinematics in free-air and after contact.
A. Distribution of whisk duration in free-air (dark green) and in contact (light green) trials. B. Distribution of whisk amplitudes in free-air (dark blue) and contact (light blue) trials. The distributions in A and B where smoothed using the MATLAB function fitdist (‘kernel’, width = 2). C. Correlations between the amplitude and duration of pairs of whisks, as a function of the interval between them. D. Whisk duration, amplitude, and set point, before the first “pseudo touch” (free-air trials; green) and the first (real) touch (contact trials; red for the ipsilateral and blue for contralateral sides).
Figure 7.
Whisking amplitudes, durations, and set-points after first touch.
A. Whisking angle of the ipsilateral C1 whisker (red) and contralateral C1 whisker (blue). Onset of the first touch in a trial is marked by a vertical line. B. Protraction amplitudes of whisker C1 as a function of whisk cycle, around first touch (red, blue) or first pseudo touch (dotted red, dotted blue). Ipsilateral C1 whisker (red, dotted red) and contralateral C1 whisker (blue, dotted blue). The most rostral untrimmed whisker C2 is touching the pole (the rare trials where whisker C1 also touched the pole in any of the first contacts were excluded from this analysis). Whisk cycle 0 is the first whisk with touch (or pseudo touch) in the trial. Asterisks indicate significant difference between ipsi and contralateral sides. We note that since the number of pseudo-touches was smaller than the number of real contacts, the error bars in the pseudo-touch trials were usually larger. C. Set point around touch as a function of whisk cycle. D. Same as B, but for retraction amplitude (negative value indicates retraction). E. Whisk duration around first touch. F. Probability of time-lags for contact and free-air trials.