Polishing of metal 3D printed parts with complex geometry: Visualizing the influence on geometrical features using centrifugal disk finishing

• Kirsten Lussenburg ,

  Roles Conceptualization, Data curation, Formal analysis, Investigation, Methodology, Validation, Writing – original draft

  * E-mail: k.m.lussenburg@tudelft.nl

  Affiliation Bio-Inspired Technology Group (BITE), Department BioMechanical Engineering, Faculty of Mechanical, Maritime, and Materials Engineering, Delft University of Technology, Delft, The Netherlands

  https://orcid.org/0000-0002-2518-9415

  ⨯
• Remi van Starkenburg,

  Roles Data curation, Formal analysis, Investigation, Methodology, Writing – review & editing

  Affiliation Department of Electronic and Mechanical Support Division (DEMO), Delft University of Technology, Delft, The Netherlands

  ⨯
• Mathijs Bruins,

  Roles Conceptualization, Data curation, Formal analysis, Methodology, Writing – review & editing

  Affiliation Bio-Inspired Technology Group (BITE), Department BioMechanical Engineering, Faculty of Mechanical, Maritime, and Materials Engineering, Delft University of Technology, Delft, The Netherlands

  ⨯
• Aimée Sakes,

  Roles Supervision, Writing – review & editing

  Affiliation Bio-Inspired Technology Group (BITE), Department BioMechanical Engineering, Faculty of Mechanical, Maritime, and Materials Engineering, Delft University of Technology, Delft, The Netherlands

  ⨯
• Paul Breedveld

  Roles Conceptualization, Funding acquisition, Supervision, Writing – review & editing

  Affiliation Bio-Inspired Technology Group (BITE), Department BioMechanical Engineering, Faculty of Mechanical, Maritime, and Materials Engineering, Delft University of Technology, Delft, The Netherlands

  ⨯